This is the machine with the Full size build-bed, about 330mm x 480mm
I'm going to only use half of it for initial testing, this is easy as I just slide out one end and change the 20mm x 20mm supports to be smaller.
This will be the smaller build bed for testing the machine (slightly over A4 sized)
I have mounted the Bowden extruder on the underside of the electronics at an angle so I can keep the PTFE delivery tube as short as possible to the hot-end.
Side view makes it a little easier to understand -
E = Electronics Box.
A = The Rubber isolation points, these provide vibration isolation and also allow the platform (B) to be angled.
B = 12mm Polycarb base.
C = Is the point where the filament enters the Extruder from the back of the machine.
D = The filament exits the extruder inside the PTFE deliver tube.
A back view of the same assembly.
More testing later and some updates to follow, it's getting close to printing now.