tag:blogger.com,1999:blog-8639215628525378898.post2262930462345873428..comments2023-09-20T15:32:40.483+01:00Comments on Reprap development and further adventures in DIY 3D printing: Hot-end for 1.75mm Filament (Push-fit Bowden)RichRap3Dhttp://www.blogger.com/profile/09348596756294999378noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-8639215628525378898.post-19216152361653161142012-05-29T21:10:05.669+01:002012-05-29T21:10:05.669+01:00Hi Ethan, they were from Technobotsonline, but you...Hi Ethan, they were from Technobotsonline, but you should be able to get them from RS or Farnell and many other places online. Check eBay also, there should be loads of them.RichRap3Dhttps://www.blogger.com/profile/09348596756294999378noreply@blogger.comtag:blogger.com,1999:blog-8639215628525378898.post-14364725602627948682012-05-29T00:34:58.498+01:002012-05-29T00:34:58.498+01:00Where did you source those pneumatic push fittings...Where did you source those pneumatic push fittings and PTFE tubing?Anonymoushttps://www.blogger.com/profile/18080727492563175988noreply@blogger.com